Indian Scientists Develop High-Performance Transistor Models, Circuits Useful For Space And Defence Applications

Indian researchers have developed a high performance industry-standard model for Aluminium gallium nitride (AlGaN/GaN) High Electron Mobility Transistors (HEMTs) with simple design procedures which can be used to make high-power Radio Frequency (RF) circuits owing to its high breakdown voltage.

Radio Frequency circuits include amplifiers and switches, which are used in wireless transmission and are useful for space and defence applications.

As AlGaN/GaN HEMTs can also extend the power level of solid-state microwave circuits by a factor of five to ten, resulting in an appreciable reduction in the overall chip size and cost, the standard developed can significantly reduce the development cost of the circuits and devices for transmitting high-frequency signals, a Science and Technology Ministry release said on Thursday (30 December).

The technology is rapidly gaining popularity owing to its high performance and efficiency. It has two excellent properties – high mobility and high-power performance. These properties reduce the noise figure and complexity while designing Low Noise Amplifiers (LNAs) (used in wireless transmission like mobile phones, base stations) while increasing the achievable bandwidth, the ministry said.

AlGaN/GaN HEMTs have become the technology of choice for high-frequency and high-power applications like 5G, radars, base stations, satellite communications, etc.

To design wideband power amplifiers, a fully robust and accurate physics-based radio frequency (RF) GaN HEMT model is of prime importance.

In the current work, the team led by Professor Yogesh Singh Chauhan at IIT Kanpur developed and standardized a physics-based compact model for AlGaN/GaN HEMTs – the Advanced Spice Model for GaN-HEMTs (ASM-HEMT).

The development of the model involved characterizing AlGaN/GaN HEMTs using state-of-the-art characterization systems integrated in a setup used for measuring the electronic characteristics like current, the capacitance of semiconductor devices, including high-frequency characteristics.

This setup, consisting of a Keysight B1500 Semiconductor Device Analyzer, an AMCAD PIV system, a passive load-pull system from Maury Microwaves, a Keysight B1505 Power Device analyzer, all connected using a FormFactor probe station, was partially supported by ‘Fund for Improvement of S&T Infrastructure (FIST)’ and Technology Development Programme (TDP) schemes of Department of Science and Technology, the ministry said.

The measurements facility funded by FIST and TDP is being heavily used by ISRO, DRDO, and other companies to characterise the semiconductor devices for high-frequency applications.

Professor Chauhan’s team measures the current, capacitance, and RF characteristics of the devices under test and uses parameter extraction tools to extract the parameters of the ASM-HEMT model for a given technology.

Once the model behavior is in close agreement with the measured characteristics, the model is validated for practical applications.

The team is concurrently working on circuit design and has delivered a state-of-the-art commercial GaAs-based LNA with one of the lowest reported noise figures in the market. Ongoing efforts include LNA, and PA design based on the AlGaN/GaN material system, the ministry said.